Installation Guide
Downton Bath End Panel
Important Information
•
Read the instructions carefully.
•
Ensure product contents are complete.
•
Check the product for any signs of damage and remove all protective film.
•
It is recommended that a technically competent installer undertakes installation.
•
It is the installer’s responsibility to carry out a thorough assessment of the installation
environment (i.e. wall type/structure) and use appropriate fixings.
•
Care should be taken when drilling to avoid any hidden wires or pipes.
•
If the panel is required to be trimmed, a fine-toothed saw should be used. Ensure that the
room is well ventilated and that any cut edges are sealed with PVA glue or silicone sealant to
prevent water ingression.
Installation
Set the height of the bath to suit the height of the bath panel according
to the instructions supplied with the bath.
Fit the end panel before installing the side panel. The bath end panel
sits behind the side panel. The thickness of the bath side panel must be
considered when scribing the bath end panel to the wall.
Ensure that when the brackets and bath panel are fitted, the panel sits
4mm proud of the bath rim.
Secure one “L” bracket to the wall using suitable fixings. It
is recommended that the bracket is fitted 300mm vertically
from the underside of the bath.
Secure th
e second “L” bracket to the underside of the
wooden batten under the bath rim using the screws provided.
Screw one of the black Keku clips to the opposite side of the
end panel to the wall. The matching Keku clip should be
screwed to the back of the front panel. Use the diagram as a
guide to how these are fitted.
Once fully installed, seal around the bath panel on all joints using a good quality, sanitary-grade
silicone sealant.
Care & Maintenance
Furniture should be regularly dusted with a soft cotton or micro-fibre cloth. For more thorough
cleaning, occasionally wipe your furniture with a soft cloth dampened with a mild detergent
solution. Surfaces should be thoroughly dried with a lint free cloth to prevent watermarks. Under
no circumstances should solvent cleaning agents, bleach or abrasive cleaning agents or cloths be
used. Glass or mirrored panels should be cleaned using a non-solvent based glass cleaner and a
soft cloth. Spills should be removed immediately using a clean cloth. All bathroom furniture will
deteriorate through prolonged periods of exposure to high levels of condensation so bathrooms
must be adequately ventilated using suitable extraction. Failure to ensure adequate ventilation
may invalidate your guarantee.
