10
EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
5. Secure the fan housing (A) to joist with suspension
brackets (E, F, G) using long wood screws (AA).
Note:
Bottom of fan housing should be flush with the
bottom of the ceiling board. When mounted correctly, the
LED panel mounting bar will hang below the ceiling board.
Optimum spacing from the bottom of the ceiling board
to the bottom of the mounting bar is 3/4 in. (5.1).
5
Mounting bar
Side view
of fan housing
Ceiling board
5.1
3/4 in.
G
E
A
AA
AA
AA
View of fan
housing from
the top
F
Hardware Used
AA
Long wood screw
x 6
6. Secure the suspension brackets (E, F) to fan housing (A)
using small machine screw (CC).
Hardware Used
CC
Small machine screw
x 3
6
CC
CC
CC
E
A
F
7. Remove wiring box cover (7.1). Pull the house wires
through the wire box cover hole. Using a quick connector,
secure 120 V AC house wiring from the wall switch to
the fan as shown in the wiring diagram on page 5. 14
AWG is the smallest conductor that should be used for
branch-circuit wiring.
Carefully push the connected wires back into the wiring
box housing. Reattach the wiring box cover (7.1).
CAUTION:
If the electrical wires do not match the colors
listed, you must determine what each house wire
represents before connecting. You may need to
consult an electrical contractor to determine safely.
7
Quick
connector
House
wires
Product
wires
7.1
7.1
7.1
7.1
8. Connect a 4 in. circular duct (8.1) (not supplied) and vent
to the outside. Secure it with duct tape (not supplied) or
clamp (not supplied) to make connection secure and
air tight.
Turn on power source. Check fan for any abnormal
sound or vibration.
8
8.1
