6 of 11
03103436-A10015 Rev. C
July 16, 2021
Seat Belt Installation
1.
Mount the seat belt D‑Loop in the existing hole in the
seat belt mounting bracket.
2. Snap open the retractor cover and insert the locating
pin at the back of the retractor into the mounting
bracket in the bulkhead wall.
3. Insert the retractor mounting bolt and tighten the bolt
to 32–49 ft•lb.
4. Snap the retractor cover down into place.
5.
Mount the safety belt bracket in the existing hole on
the seat pedestal.
6.
Mount the seat belt latch on the inboard side of the
seat with the release button facing away from the
seated driver.
Jump Seat Belt Replacement
The outboard side refers to the side closest to the door (jump seat occupant’s right-hand side).
The inboard side is the side toward the center of the vehicle.
Jump Seat Belt Removal
1. Remove the bolt attaching the D-Loop to the
bulkhead above the seat on the outboard side.
2. Snap open the retractor cover and remove the bolt.
3. Remove the bolt holding the seat belt bracket to the
seat belt mount just below the seat on the outboard
side.
4.
On the inboard side of the seat, remove the bolt
holding the seat belt buckle assembly.
Retractor uncovered
D-loop attached to mount bracket
D-LOOP
NUT
COVER
D-LOOP
NUT
COVER
The retractor must be located in the proper position on the bracket for the
seat belt web to extract and function properly.
When a seat belt is replaced, both halves must be replaced.
