NX-535N-V3 Voice Module Installation Manual
6
Configuring handshake and kiss off
Handshake and kiss off can be programmed as any key press or as a specific
telephone key. The following steps explain how to configure these digits.
Note:
The voice protocol cannot generate a ‘fail to communicate’ signal.
1. Navigate with the
keys to NX-535 Voice Module>Handshake Digit and
press OK.
2. Select the handshake digit and press OK.
3. The keypad beeps once to accept the change.
4. Scroll to Kiss Off Digit and press OK.
• Select the kiss off digit and press OK.
• Select Any Digit to program any key press as the handshake/kiss off digit.
This is the default.
• Select None to disable kiss off.
5. The keypad beeps once to accept the change.
Glossary
Location Term
Definition
11 NX-535N-V3
Voice
Module
A module used to send pre-recorded voice
messages when activated.
11.
Recording
A menu entry that groups recording options for
messages sent by the voice module.
11.1.1 Leader
Message A menu command that records the leader message.
This message is sent by the NX-535N-V3 voice
module at the start of a voice reporting phone call.
11.1.2
Single Event Message
A menu command that records a single event
message. This message is sent by the voice
module and states the event that has occurred.
11.1.3
Address Message
A menu command that records the address
message. This message is sent by the NX-535N-V3
voice module and states where an event has
occurred.
11.1.4
Kiss Off Message
A menu command that records the kiss off
message. This message is sent by the NX-535N-V3
voice module at the end of a voice reporting phone
call to indicate that the kiss off digit has been
received.
11.2
Playback
A menu entry that groups options that allow the
installer to play back recorded voice messages.
