USTER HVI SPECTRUM, Инструкция по эксплуатации

Страница: 147 / 230

USTER
® HVI SPECTRUM
Instruction Manual
Uster Technologies, Inc. Chapter 10
Bale Manager • Page 10-15
The Select Property field is used to indicate the property that is of the
category being defined (i.e. Length/Strength, elongation, etc….).
The cursor is positioned in the
Highest Value of First Category
field for the highest value for the first category. This is the value at
which the fiber property's first category should end. All bales that have
a measured value at or below the value entered here will be included in
this category.
The
Interval Between Categories represents the range between
categories. Bale Manager uses the interval to determine where the next
category should begin. The sample test results are assigned to
categories according to where the test results fit. The interval between
categories differs according to the fiber property. If the intervals are
small, an excessive number of categories might be created. On the
other hand, large intervals between the categories may not give good
control of the variation within a mix or between mixes.
Categories will be assigned numbers in sequential order beginning with
this number. The
Number of First Category field is used to indicate
what number to use to begin numbering the categories. If you do not
enter a number, the categories will be numbered starting at one
(1) .
A maximum of 20 categories for each fiber property can be entered in
the
Number of Categories field. To keep warehousing as simple as
possible, limit the number of categories to the smallest number
reasonable for the range of your inventory.
•
Enter the information requested in each field and select the
OK
button to save the data. Repeat the entry for each applicable
property.
Categories should ONLY be changed if the laydown
of the remaining bales in the warehouse can be
changed accordingly
.