USTER HVI SPECTRUM, Инструкция по эксплуатации

Страница: 102 / 230

USTER
® HVI SPECTRUM
Instruction Manual
Uster Technologies, Inc. Chapter 7
Testing Procedures • Page 7-8
Note:
Allow the balance time to stabilize and make the correct
reading before removing the fiber. The system will not accept the results
until a stable reading is taken.
•
When the sample weight is within range, the weight is displayed in
the
WGT field on the
HVI SPECTRUM
T
ESTING
screen.
•
Insert the weighed sample into the micronaire chamber and close the
lid. The micronaire test will begin automatically.
•
The chamber lid will open once the test is completed and the sample
is ejected from the chamber.
•
The micronaire value will be displayed in the box for MIC in the
Micronaire area.
•
The maturity of the cotton will be displayed in the box for MAT after
the length/strength measurement tests are complete.
Note:
Maturity Index is an optional setting.
If the Micronaire value is outside the set limits:
•
Select the N
EW
T
EST
button to accept the value and proceed with
testing.
•
To reject the value and perform another test sequence on the sample,
press the
R
EJECT
T
EST
button and then press the N
EW
T
EST
button.
•
Checking the “…
AND
NEP” box allows you to reject NEP data as
well as other data.
Note:
If an error message appears repeatedly, it could indicate an air
leakage in the micronaire chamber. In such a case, perform a
micronaire calibration check to ensure that it is accurate. If necessary,
contact an Uster Technologies’ Service technician for further support.