10
REMOVING FRONT SCREEN
WARNING
FRONT SCREEN
The front screen must be in place at all times when the appliance is operating. Do not obstruct the screened openings
of the heater.
The positioning of the logs is critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly
situated in the appliance. Never add additional logs or embellishments such as
pine cones, vermiculite or rock wool to the heater.
FIGURE 8. Log Set Assembly
#1
#2
WARNING: Failure to position the
parts in accordance with these dia-
grams or failure to use only parts spe-
cifically approved with this heater may
result in property damage or personal
injury.
LOG POSITIONING
This unit is supplied with a set of four ceramic fiber logs. Do not handle these logs with your bare hands! Always
wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with soap and
water to remove any traces of fibers.
PROPER INSTALLATION SEQUENCE:
1. Install the rear log (#2) on the rear set of locators. Visually check to verify the log is securely placed on the locators.
2. Install the front log (#1) on the front locators. Visually check to verify the log is securely placed on the locators.
3. Install the left and right cross twigs as illustrated, on the locator pins provided in the front and rear logs. Holes
provided in the bottom of the cross twigs should allow them to seat completely over these pins.
1) Lift the front screen slightly up (Fig. 7A) and then tilt the bottom of the screen inward and downward (Fig. 7B). 2)
Lean the top of the screen toward you slightly (Fig. 7B) and then proceed to carefully bring the screen straight back
(Fig. 7C). NOTE: To reinstall the front screen, reverse steps 1 & 2.
LOG ASSEMBLY
FIG 7C
FIG 7B
FIG 7A
