7
Figure 4: Transit Screws
7.
Connect power supply to the QMR’s 24vdc input. See Figure 5.
The systems power supply must be connected to an earthed (grounded)
power supply of 90 - 260V, 50 - 60Hz. Only personnel trained to avoid the
risk of electric shock should remove the covers on the equipment. The
power supply to the equipment must be switched off and disconnected
before removing any covers. Do not make or break external connectors
or connections while the system is switched on.
8.
Connect the positive pressure to the QMR ’s air inlet port or external vacuum supply
(optional).
9.
Connect printer cable (optional).
10.
Connect serial communication and power cables to the printer (optional).
See Figure 6.
11.
Connect main inlet to power supply unit.
12.
Turn the QMR power On. See Figure 5.
13.
Connect specified air supply, then turn air or vacuum On to the system. Unit will go
through a boot-up sequence.
Figure 5: QMR Power/Air Connections
Power Receptacle
QMR On/Off Switch
Air Inlet
Serial Communications/Printer
