If you choose to use an aerosol smoke product to test the smoke alarm, be certain to use
one that has been Listed to Underwriters Laboratories, Inc. Safety Standards and use it
only as directed. Use of non-UL Listed products or improper use of UL Listed products may
affect the smoke alarm's sensitivity.
NUISANCE ALARM SILENCE FEATURE:
This feature is to be used only when a known alarm
condition, such as smoke from cooking, activates the smoke alarm. The smoke alarm Silence
Feature is activated by pushing and releasing the Silence button on the smoke alarm cover while
in alarm condition. The smoke alarm will automatically reduce sensitivity and the red LED will
blink on approx. every 10 seconds to indicate the alarm is in the Silence mode. The smoke alarm
will gradually regain normal sensitivity and sound the alarm if particles of combustion are still
present. The approx. 10 minute Silence feature may be used repeatedly until the air has cleared,
by pushing and releasing the Silence button again. Resetting the smoke alarm after a nuisance
alarm is recommended.
NOTE: If the Test button is pressed and held during the Silence mode, the smoke alarm will be
tested normally. Upon the release of the Test button, the Silence mode will be restarted.
REGULAR MAINTENANCE:
Test the alarm at least once per week to verify it is operating properly.
Clean this alarm at least once a month to remove dust, dirt, insects and debris. Using a soft brush
or wand attachment to a vacuum cleaner, vacuum all sides and cover of smoke alarm. Be sure all
the vents are free of debris.
DO NOT use spray cleaning chemicals or insect sprays directly on or near the alarm. DO NOT paint
the alarm. Doing so may permanently damage the alarm and interfere with alarm’s ability to sense
smoke. The outside can be wiped with a damp cloth. DO NOT use any household cleaning agents,
solvents or sprays including compressed gas dusters or any other chemical on or near your alarm.
DO NOT disassemble or attempt to clean inside the alarm. This alarm contains no serviceable parts.
If the alarm becomes contaminated by excessive dirt or grease, and cannot be cleaned, it should
be replaced immediately. Alarms have a limited life and should always be replaced 10 years from
the date of purchase.
AFTER CLEANING, REINSTALL YOUR ALARM AND
TEST YOUR ALARM BY USING THE TEST BUTTON
Page 8
BATTERY AND ALARM DEACTIVATION
This alarm uses a sealed battery. The battery should last for approximately 10 years under normal
operating conditions. The smoke alarm has a low battery indicator which is 2 chirps approx. every
60 seconds. The red LED blinks on once approx. every 2 minutes.
Due to the loud 85 decibel alarm, stand at arm's length away from the alarm or use ear protection
when testing. Weekly testing is required to ensure proper operation. Irregular or low volume sound
may indicate a defective alarm and it should be returned for service. Follow instructions to prepare
alarm for shipment or disposal.
Deactivation of the alarm is permanent.
Do not attempt to open the alarm for any reason.
Place this alarm into shut-down mode at the end of its useful service life. Once the smoke alarm
has entered end-of-service-life mode, it is necessary to deactivate the alarm operation. This will
stop the product end-of-service-life warning signal and also discharge the remaining capacity of
the battery to render it safe for disposal.
1. Remove the alarm from the mounting bracket by rotating it in the direction shown by the arrows
on the rim of the base.
2. The alarm deactivation key is located in the mounting bracket of the alarm.
3. Use a small flat blade tool to remove the deactivation key (breakaway) from the mounting
bracket.
4. Push tip of key into the deactivation slot (keyhole) outline on label and insert fully.
5. Turn key clockwise to the “off” position slowly until you feel the switch actuate and the key
stops turning.
6. This will discharge the alarm battery and stop the alarm chirping after approximately one
minute. The alarm is now safe for disposal.
7. The deactivation key cannot be removed and the alarm cannot be attached to the bracket.
8. Be sure to install a new alarm.
