USASPEC BSM 200, Руководство по эксплуатации продукта

Страница: 11 / 16

8
Connecting the Cables
1. Connect the BSM-200 main harness to the two sensors. See
Fig. 4.
• Note: connect the longer plug of the main harness to
the passenger-side sensor.
• Connect the vehicle’s left turn, right turn, and reverse
signal lines to the corresponding wires on the BSM-200
main harness lines
• Right turn signal’s +12v to the green/white wire
• Left turn signal’s +12v to the green wire
• Reverse light signal’s +12v to the yellow wire
• Run the BSM-200 main harness down the driver side
towards the driver-side kick panel or under the steering
wheel column near the vehicle’s OBD-II port
2. Install the LED indicators to the driver and passenger side
A-pillars. See Fig. 5 for other suggested locations.
• Run the LED indicator lines to the driver-side kick panel
or steering wheel column and connect the LED lines to
the corresponding left and right LED plugs on the BSM-
200’s 6-pin harness. See Fig. 6.
3. Install the speaker under the steering wheel column and
connect it to the corresponding plug on the BSM-200’s
6-pin harness. See Fig. 5 & 6
4. Connect the BSM200 OBD-II harness into the vehicle’s
OBD-II port located underneath the dashboard
5. Connect all three BSM200 harnesses to the BSM 200
Control Module’s corresponding ports. See Fig. 7.
6. Connect power: connect the RED wire from the main
harness to the vehicle’s ignition or ACC +12v source.
Connect the black wire to a ground terminal or a bare metal
surface
7. Mount the BSM200 control module on an easily accessible
location