9
16
. At the top and bottom of each side rail you
will see 4 predrilled holes, 2 at the top and 2 at
the bottom. Use the 1 1/2” countersink screws to
secure the top and bottom of the side rails to the
head and foot rails, except for the predrilled hole
located closest to the big hole in the side rails.
Make sure that toe tops and sides where the side
rails meet the head and foot rails are flush when
you screw in the 1 1/2” countersink screw.
17
. (1) There are 3 predrilled holes, in the
side rails the hole in the middle of the 3
holes gets the white foot stopper. (2&3) Use
the 3 1/4” washer head screw and thread it
through the white foot stopper. (4&5) Then
drill it into the final pre drilled hole on each
side rail. Now secure all of the cams in the
side, head and foot rails.
Note:
Failure to place the screws as shown could
cause failures of the side rails.
18
. Locate the 3 “I” cross rails. These will be
your support beams and will go perpendicular to
the side rails so the notch in the I rail fits over the
support strip. There should be 3 on each side rail
and the first ( the thicker of the three ( diagram
1)) approximately 10 ” from the foot or head rail.
19
. Using the L Brackets and the 5/8 washer
head screws from bag #4, attach the I rails to the
side rail, placing the bracket over the support
strip.
1)
2)
3)
4)
5)
