11
23
. Locate the Mattress Panels (JL, JC,
JR). Stand at the top of the face panels
(where the legs and rod are) and place the
panel labeled JL on the left with the elastic
towards you. (1&2) Mark where the Cross
rails are underneath it so you know where
to screw into the mattress panel to attach it
to the cross rail. Place the center mattress
panel in the center and mark on the panel
where the cross rails are underneath it. Do
the same with the right mattress panel,
making sure that the elastic is towards you
and not up by the head rail. (3) Place eight
1 1/2” countersink screws into the center
panel to attach it to the bed. 2 where the
strip is of the head rail, 2 in each cross rail
and 2 in the foot rail strip that it is sitting
on. (4) Remove the left and right mattress
panels.
24
. Locate the 4 mechanism fixture bolts
and nuts. While standing at the bottom of the
face panels (head rail side), on the side rails
there are 2 holes on each near your end. (1)
Place a bolt in the upper most of the holes on
each side (2) going from the outside in and put
the nut on the bolt from the inside. Do not
tighten, you want the bolt to be sticking outside
of the side rail.
Note: The large washers must be on the inside
of the bed
25
. Depending on what type of bed you have will depend on how many springs to put onto the mecha-
nism. The following is an estimated amount of how many springs we usually use for each type of bed.
Each mattress is different in weight so yours might need one extra spring or one less spring.
VERTICAL BEDS:
King: 9 Springs
Queen: 7 Springs
Full: 6 Springs
Twin: 5 Springs
Queen with table: 8 Springs
Full with table: 7 Springs
Twin with table: 6 Springs
Queen with desk: 7 Springs
HORIZONTAL BEDS:
Queen: 4 Springs
Full: 3 Springs
Twin: 2 Springs
Again, these are our estimated amounts based on what we usually use for these types of beds, we do not know
what kind of mattress you will be putting on your bed. Try putting this amount on and follow the instructions. It
will instruct you how to tell if it is the incorrect amount as well as how to fix it in later steps.
1)
2)
3)
4)
5)
1)
2)
3)
