US Shift 4L60E, Инструкция по установке и эксплуатации

Страница: 35 / 40

35
Shift Solenoid A (SSA) circuit open
The indicated Shift Solenoid’s resistance measured too high during the power-
on solenoid check. Refer to the data display screen in the diagnostic menu to
see the measured solenoid resistance.
Shift Solenoid B (SSB) circuit open
The indicated Shift Solenoid’s resistance measured too high during the power-
on solenoid check. Refer to the data display screen in the diagnostic menu to
see the measured solenoid resistance.
3-2 D/S Solenoid circuit open
3-2 downshift solenoid resistance measured too high during the power-on
solenoid check. Refer to the data display screen in the diagnostic menu to see
the measured solenoid resistance.
TCC On/Off Solenoid circuit open
TCC on/off solenoid resistance measured too high during the power-on solenoid
check. The controller will attempt to disable both TCC solenoids until the ignition
is turned off. Refer to the data display screen in the diagnostic menu to see the
measured solenoid resistance.
TCC PWM Solenoid circuit open
TCC pressure solenoid resistance measured too high during the power-on
solenoid check. The controller will attempt to disable both TCC solenoids until
the ignition is turned off. Refer to the data display screen in the diagnostic menu
to see the measured solenoid resistance.
EPC (PCS) Solenoid circuit open
Line Pressure Control Solenoid resistance measured too high during the power-
on solenoid check. Refer to the data display screen in the diagnostic menu to
see the measured solenoid resistance.
TPS Voltage Low; run TPS Setup
The Throttle Position Sensor is in fault mode due to the voltage being below the
idle threshold value that was set. Run TPS calibration in the setup menu.