US Praxis PRX130, Руководство пользователя

Страница: 21 / 49

US Praxis, Inc. – Copyright 2009 © All rights reserved
21
OPERATING THE MACHINE
­Continued­
1. Place stump machine into position with cutting
blade near the front­top edge of stump.
2. Set brake to lock position.
3. Set throttle to (START) DISENGAGE position.
4. Start engine.
5. Allow engine to warm up at idle for two minutes.
6. Move throttle up to the ENGAGE position (this
will engage the cutting blade rotation).
7. Swing the cutting blade to one side, then lower it
approximately 1/2" to 1" into the front­top
corner of the stump. Swing the cutting blade
back and forth, lowering the cutting blade
approximately 1/2" to 1" before each sweep, until
you have removed the front portion of the stump
to ground level.
8. Raise cutting blade until center of cutting blade is
just above top of stump.
9. With the cutting blade off to one side, advance
the machine horizontally by releasing and
resetting the brake. Advance the machine
forward to engage the cutting blade into the
stump so that when swept across the stump it will
remove 1/2" to 1" of stump with each sweep.
10. Sweep the cutting blade across the stump, cutting away 1/2" to 1" of stump.
11. Advance cutting blade 1/2" to 1", and sweep
across stump in opposite direction.
12. Continue sweeping cutting blade left and right
across stump, advancing it before each sweep,
cutting 1/2" to 1" depth of stump with each
sweep.
13. Continue cutting until top level of stump is all
removed, making sure not to cut stump deeper than ground level during this first stage.
OPERATING THE MACHINE