7
E N G L I S H •
User’s manual
GENERAL SAFETY RULES
WARNING: Read and understand all instruc-
tions. Failure to follow all indications listed below,
may result in electric shock, fire and/or serious per-
sonal injury. SAVE THESE INSTRUCTIONS.
RECOMMENDED USE: With light and self collaps-
ing grease up to NLGI No. 2.
• Pump dispenses grease at pressures upto 50
times the air inlet pressure.
• Designed to work in tough conditions- ideal for
use in industry, workshop, farm, construction or as
part of the mobile grease system.
• Reciprocating piston operated 2.5” (63 Mm) dia.
Air motor.
WARNINGS
• Always wear protection gear like safety goggles,
gloves, apron, and ear plugs while operating the
pump.
• Never let any body part come in front of, or in
contact with the control outlet.
• Always cut off air supply after use, so that media
cannot leak incase any of the pump component fails.
• Before switching the air supply on, check hoses
for sign of wear, leak or loose fittings. Replace as
necessary.
• Do not smoke near the pump. Do not use the
pump near a source of spark / open flames
• When changing the working fluid, at least 1 litre
of new fluid should be discarded to avoid mixing
of fluids.
• Pump should NOT be operated for more than 4
hrs continuously.
• Pump must be supplied with CLEAN & DRY com-
pressed air via an FRL unit.
• Before attempting any maintenance or repair
of this product, disconnect air supply and then
squeeze control valve trigger to release fluid pres-
sure.
• Use only genuine factory parts for repair.
• In case of accident, immediately seek medical
attention. Do not try to treat the injury yourself.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become fa-
miliar with all of its operating features and safety
requirements.
1. GREASE PUMP
2. DRUM COVER.
3. COVER SCREWS.
4. GREASE DRUM.
5. WHEELS.
6. HIGH PRESSURE RUBBER HOSE.
7. Z SWIVEL.
8. GREASE CONTROL VALVE.
9. PULL HANDLE
PUMP CONSTRUCTION
The pump is made up of two sections as given be-
low:
• Drive section: It con-
sists of an Air Motor
Assembly driven by
compressed air. The pis-
ton diameter of the air
motor is 2.5” (63 mm).
The motor consists of
an air cylinder with
piston and one recipro-
cal valve with a nylon
slider. The valve directs
the compressed air al-
ternately to the top or
bottom of the piston,
thus producing a recip-
rocating motion of the
piston rod.
• Pumping Section: It consists of a pump in which
a piston lifts the grease through Non Return
Valves by reciprocating inside the pump cylinder.
The grease is discharged with pressure (from the
outlet located at bottom of Air Motor) into the
delivery hose.
IMPORTANT: AIR MOTOR of these pumps starts
automatically when the Grease Control Valve is
Sección de
transmisión
Sección
de bombeo
1
2
9
3
4
6
7
8
5
Содержание 23629
Страница 11: ...11 Manual de usuario User s manual Notas Notes...
