DOOR 1: controlled by channel 1
DOOR 2: controlled by channel 2
1. Entering programming Mode
To program the unit, you must first enter in PROGRAMMING mode. In programming mode, the remote controls
are not read and cannot control the doors. The pushbutton operates except during use of functions
F4
and
F5.
If the unit does not have a password :
Press one of the three programming buttons
.,
or .The unit displays
00
If the unit has a password :
Enter the password using the three keys. A password is a combination of six pressings on the
keys
,
, and . For example :
,
, ,
, ,
If the password is correct, the unit displays
00
otherwise it displays
err
followed by two series of digits. Try again
or note these digits and indicate them to your distributor.
You can then use the arrows and to scroll the numbers from
001
to
999
(or
500
depending on the version)
to store the remote controls and from
F1
to
F5
to modify the unit parameters.
In programming mode, the central point does not indicate the state of the power supply. It is used to indicate that
a code is read on the programming reader.
2. Storing the remote controls
Display a position between
01
and
999
(or
500
depending on the version) using the
and
keys. (If the
position contains a code, at least one of the points on the left or the right of the display lights up. To modify the
authorisation, press )
Present the remote control on the reading zone on the right of the display. After the code has been read, the
central point lights up. (If the code already exists in the memory, the unit ignores the position you have chosen
and displays the position at which the code is programmed. You can then modify the authorisations).
Use the arrows
and
to display:
- the point on the left of the display to authorise Channel 1 on door 1,
- the point on the right of the display to authorise Channel 2 on door 2,
- both points to authorise both channels of the remote control.
(If you do not authorise any door, the operation will be cancelled)
Validate with the key .
3. Cancelling a remote control
Display a position between
01
and
999
(or
500
depending on the version) using the
and
keys.
(If the position contains a code, at least one of the points on the left or the right of the display lights up)
To cancel the code, keep the key pressed for 1 second: the display flashes once and the
points on the right and on the left disappear.
4. Exiting from programming mode
To exit from programming mode, press
and
simultaneously.
: Exit from programming mode is automatic if no key is pressed for 30 seconds
TO MODIFY THE PARAMETERS OF THE UNIT REFER TO PAGE 16-17
9
50-000-611 DOC TRANSIT GB FDI
C
