urmet domus FDI Transit FD-010-012, Руководство по установке

Страница: 16 / 19

PROGRAMMING THE CONTROLLER PARAMETERS
CAUTION: DURING PROGRAMMING, THE KEYS AND REMOTE
CONTROLS ARE NOT READ AND CANNOT OPEN THE DOORS. IN ADDITION,
WHEN YOU USE FUNCTION F4 OR FUNCTION F5, THE PUSHBUTTON
CANNOT CONTROL THE DOOR.
1. Function F1: Password
Enter a password in the controller :
Enter programming mode. Display function
F1
using and keys
Validate with the key : the indication F1 disappears and COD is displayed.
Enter a combination of 6 keys using
, and . For example : , , , , ,
The indication COD begins to flash.
Confirm the password by entring the same combination again. If the confirmation is correct your
password is validated; the unit displays F1 Otherwise the readout indicates err and the unit automa-
tically goes to the position 00 . In this case, the old password remains valid.
Delete a password: ( To modify a password, you must know the existing password )
Enter programming mode. Display function
F1
using and keys
Hold the key pressed down for 1 second : the display flashes once and the password is deleted.
2. Function F2: State of Pushbutton entries
Enter programming mode. Display function F2 using and keys, then validate with the key
The readout then indicates the state of the pushbutton of door 1 : for example NO means that the
state of the pushbutton of door 1 is NO ( Normally open ).
To display the state of the other entry, use and keys.
To modify the state of the selected entry, press the key : The number of the entry then remains
displayed while the state NO or NC flashes.
To change the state, use and keys. To validate the state use the key : The display
indicates F2 again.
Meaning of display indications in function F2 :
1NO : State of pushbutton of door 1 : Normally Open
1NC : State of pushbutton of door 1 : Normally Closed
2NO : State of pushbutton of door 2 : Normally Open
2NC : State of pushbutton of door 2 : Normally Closed
PROGRAMMING THE CONTROLLER PARAMETERS
16
50-000-611 DOC TRANSIT GB FDI C