DS1099-106
5
Privacy and Copyright
The IP camera is a CCTV system device. Recording of imagines is subject to the laws in force in your country.
Recording of images protected by copyright is forbidden.
Product users shall be responsible for checking and respecting all local rules and regulations concerning monitoring
and recording video signals. The manufacturer SHALL NOT BE LIABLE for use of this product not in compliance with
the laws in force. For more information see http://www.garanteprivacy.it.
Firmware upgrades
Periodically check the URMET Customer Service Technical Area for firmware upgrades.
Network configuration
The camera is set to DHCP mode. If the network on which it is installed does not support dynamic addresses (DHCP),
the camera will automatically activate the default IP address 192.168.10.168. The “
Easy Tool
” Urmet software can
be used to change the default IP address and other network configurations of the camera to prevent conflicts with
other devices on the network. Always check the warnings for restrictions concerning the address which can be
assigned to the camera.
Network connections
When connecting a PC (using Software Client or Browser), any video channel on the PC will be using “unicast” connection
(TCP, RTP, UDP).
The device can support a limited number of “unicast” connections so it is possible to show the video on maximum 4 remote
devices (of which 2 smartphones at the most) at the same time depending on the available network band.
Reset button
Press for at least 3 seconds: the camera is completely reset and goes back to default settings.
IMPORTANT NOTE:
the camera loses network configuration and the WiFi interface returns to Access Point mode.
2 SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, URMET S.p.A. declares that the radio equipment types: cameras 1099/214, 1099/216, are in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.urmet.com
3 INSTALLATION
3.1 1099/214
WIFI BULLET FIXED LENS CAMERA
It is advisable to proceed as follows for correct camera installation and configuration:
1. Make sure that no units are powered before starting the installation procedure. Fit the aerial on the camera. It is advisable
to install and configure one camera at a time if you are installing multiple cameras on the same network.
2. Connect the camera to the network (see section 4). It is advisable to check that the WiFi signal received by the camera
is higher than or equal to 60.
3. Position the camera in a point on the wall or other surface and adjust the bracket to frame the required scene.
4. If you want the camera to record and store video files on a micro SD card (not included), plug the card into the slot when
the camera is powered off (see the picture below). Power on the camera and use the camera’s wepgabe or the app to
format the card before starting the recording function.
5. If you are using a NVR/HVR device, assign a static IP address to the camera (4.6) and use the NVR/HVR menu to add
the camera to a recording channel.
