11
2.6.
Matching code for wireless foot switch
1)
Press and hold the three keys "G", "P" and "E" at the same time until the indicator light of liquid slider starts to
flash slowly under the device is power on.
2)
Keep foot switch pressed and insert two AA batteries (operate when indicator light of liquid slider starts to flash
slowly at the same time) ,and then foot switch will enter matching mode and it should keep pressed state for 3
seconds after it is power on.
3)
Loosen foot switch and restart, and the device can be controlled by wireless foot switch.
4)
Press and hold the three keys "G", "P" and "E" at the same time when these three modes are at 10
scales
, and
the device will cancel all match.
5)
Press and hold the three keys "G", "P" and "E" at the same time when the
liquid flow rate
is 10
scales
, the
device will enter the calibration mode of
liquid flow rate
. Don’t enter this mode under normal circumstances. If
necessary, please contact the dealer or contact the manufacturer.
Figure 2.7
7
Note:
Tear off the membrane behind the sticker and
stick it on the bottom of foot switch for waterproofing
Press "1" to start the device.
https://stomshop.pro
