URIPHON wireless 2, Инструкция по эксплуатации

Страница: 17 / 28

17
Stopping the alarm:
The procedure for stopping the alarm, which may appear a little laborious but is actually
designed to prevent the wearer is accidentally turning off the alarm while half-asleep.
Procedure is as follows:
•
Disconnect the snap fastener between Transmitter and contact pad.
The alarm signal continues until the alarm is switched off.
•
To switch off the alarm, press the button "Alarm Stop" (fig. 5) on the Receiver.
The alarm signal stops. The orange LED “Transmitter display" (fig. (5) goes out.
•
Important note: The "alarm stop" button on the receiver responds only when
the contact between the pad and the Transmitter is disconnected. That is when
the electrical connection through the urine on the contact pad is disconnected.
After having been to the toilet and having emptied the bladder, dry pants and a new
contact pad must be worn. Once the connection to the Transmitter is restored, the
system is ready to go again. The patient can go back to sleep.
Especially at the beginning of therapy, depending on the age of the wearer, the
procedure may require more or less assistance from parents or helpers.
Summary of the Receiver displays (fig. 5)
a)
LED display for the Transmitter’s operating mode
•
Only the orange coloured LED (drop symbol) lights up: The alarm is triggered,
the sensor is wet
•
Only red LED (battery icon) flashing: The battery in the Transmitter is weak
and must be replaced.
•
Both LEDs are lit: The device is in pairing mode
b) LED display for the operating mode of the Receiver
•
Both LEDs off, no display: Device is running on battery and batteries have
sufficient charge.
•
Red LED flashes: The Receiver batteries have to be replaced
•
Green LED: Device running on power supply
Important note: The functions described only appear if there are batteries in
the Receiver and/or the Receiver is operating through the power supply.