2. Insert the latch on the top of the handle into the assembly hole on
the bottom of the control box. Then slightly push the control box in the
direction of IN marked on the handle to fix the latch in place. Secure
the control box with fixing screw properly.
3. Unscrew the knob on the search coil and remove the knob connector.
Insert the stem and align the holes on the search coil bracket and the
stem. Push the connector through the holes and tighten the knob.
4. Wind the search coil cable around the stem. Leave enough slack in the
cable. Insert the search coil cable plug into the five pin jack on the front
control box’s housing.
5. Turn the stem
’s lock nut clockwise until it loosens. Lengthen or shorten so
when you stand upright with the detector in your hand, the search coil is
level with and about 1/2 to 2 inches above the ground with your arm
relaxed at your side. Turn the stem
’s lock nut counter-clockwise to lock it
in place.
Caution:
The search coil
’s plug fits into the connector only one way. Do not force
the plug or you could damage it.
Do not over tighten the search coil or use tools such as pliers to tighten
it.
INSTALLING BATTERIES
1. Turn off the power before installing the batteries.
2. Slide the left and right battery covers off in the direction of the arrow.
3. Place two 9V batteries into the battery compartment matching the polarity
symbols (+ and -) marked inside.
3
