Upsen Queen Star Series, Руководство пользователя

Страница: 36 / 44

35
8. Chapter Operation (LCD model)
Figure 8-3 Battery Mode
2) When the battery capacity decreases, the number of load/battery capacity
indicators turned on will decrease. If the battery voltage drops to the
pre-alarm level (capable of maintaining the backup time for more than 2
minutes), the alarm will beep every second to remind the user of
insufficient battery capacity.
3) The other four display pages are load percent page, actual load page,
battery information page and the maximum temperature page.
8.2.3 Bypass Mode
When operating in bypass mode set up through UPSilon software, the
display on the front panel is shown as the figure 8-4, the utility power
indicator and the bypass indicator are turn on. The load/battery capacity
indicator will be turned on in accordance with the load capacity connected.
Load information area shows load value, and the battery level area
indicates dynamically when the battery is not full charged (the battery level
icons lit one after another circularly). When the battery is full charged, all
the level icons are turn on.
1) When operating in bypass mode, the UPS beeps every 2 minutes. If the
“Function” key is pressed for more than 5 seconds, the alarm will not
beep (silence function). Press the “Function” key more than 5 seconds
again to resume the alarm function.
2) If the utility power indicator blinks, it shows that the voltage or
frequency of the utility power is out of the input range of the UPS or
there are problems with reversed polarity (L/N) of site wiring or
disconnect to the ground for protection.