Upsen Queen Star Series, Руководство пользователя

Страница: 22 / 44

21
4. Operation and Operating mode
current output frequency setting value.
3) If you need to set the voltage, check the voltage setting is enabled (the
inverter indicator is lit), if not, press the ‘F’ more than one second, then
release, the inverter indicator will be turn on, at this point you can start
to set output voltage.
4) Release the ‘OFF’ key after you press it more than one second, the next
load led indicator will be turn on.
5) Repeat the fourth step until the No of lighted load indicator meets the
required voltage.
6) Press ‘ON’ key about one second, the output voltage setting completed.
7) The frequency setting is the same as the voltage setting, but before the
setting, please confirm the frequency setting is enabled (the inverter
indicator blink), if not, press ‘ON’ key about one second in order to
switch to the frequency setting screen.
8) When done, Press the ‘F’ and ‘OFF’ button more than one second, then
release, the buzzer will beep once, exit the setting mode.
In the setting process, if no key is detected within twenty second, the UPS
exits the setting screen automatically.
The relation of the No of lighted load led and voltage/ frequency as
follows.
Note: L1 ~ L4 are the green lights, L5 is the yellow light, L6 is the red
light.
4.2.6 Backup time for the standard model
The backup time of the long backup time model is dependent on the
external battery pack capacity and the load level as well as other factors.
The backup time of standard model may vary from different models and
load level.