UPS Aviation Technologies Apollo SL10, Руководство по установке

Страница: 13 / 30

UPS Aviation Technologies
SL10 Series Audio Selector Panel and Intercom System
Installation Manual
2-6
Adjustment Clockwise Results In
Cabin Speaker Level Increase Speaker Volume
Marker Beacon Level Decrease Marker Volume
MKR Gain Increase overall sensitivity
MKR High Sense Increase sensitivity
MKR Low Sense Increase Sensitivity
Pass. Headphone (Mono or L & R) Louder
To make the necessary adjustments, use a small jeweler's
slotted screwdriver.
Figure 2-1 Adjustments
2.6 Marker Antenna Installation
Refer to aircraft and antenna manufacturer's installation
instructions, as well as AC43.13-2A (or later revision),
Chapter 3, for information on proper antenna installation
techniques. The marker beacon antenna must be
mounted on the bottom of the aircraft.
2.7 Communications Antenna Installation Notes
For best results while in Split Mode, it is suggested that the one VHF communications antenna be located
on top of the aircraft while the other communications antenna be on the bottom. Any antenna relocation
must be accomplished in accordance with AC 43.13-2A, aircraft manufacturers’ recommendations and
FAA-approved technical data.
Warning : It is probable that radio interference will occur in the split mode when the frequencies
of the two aircraft radios are adjacent, and/or the antennas are physically close together. UPS
Aviation Technologies makes no expressed or implied warranties regarding the suitability of the
SL10 in Split Mode.
2.8 Unit Installation
2.8.1.1 Monaural (SL 10, SL10M)
To install the monaural SL10, remove the copilot volume and squelch knob. Gently slide the unit into the
mounting rack until the hold-down screw is engaged. While applying gentle pressure to the face of the unit,
tighten the 3/32" hex-head screw next to the copilot control shaft until the unit is secure. DO NOT OVER
TIGHTEN. Reinstall the knobs removed in step 2.3.3.1.
2.8.1.2 Stereo (SL10S, SL10MS)
To install the stereo SL10S, gently slide the unit into the mounting rack until the hold-down screw is
engaged. While applying gentle pressure to the face of the unit, tighten the 3/32" hex-head screw next to
the squelch control shaft until the unit is secure. DO NOT OVER TIGHTEN.
Warning : Do not over-tighten the lock down screw while installing the unit in
tray.
Internal damage will result.
MKR Hi Sense
(211)
MKR Audio Level
(233 )
MKR Lo Sense
(231)
MKR Gain
(223)
Cabin Speaker
Level (111)
Pass
Volume
Level
Mono
L (123)
R (113)