Uponor Smatrix Move, Быстрое руководство

Страница: 7 / 268

UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
7
U P O N O R S M AT R I X M O V E · Q U I C K G U I D E
Q U I C K G U I D E
Installation
W
arning
!
The Uponor system uses 230 V AC, 50 Hz
power. In case of emergency, immediately
disconnect the power.
C
aution
!
To avoid interference, keep installation/data
cables away from power cables of more than
50 V.
1. Attach the controller to the wall by using wall
screws and plugs.
If the controller is installed inside a metal cabinet,
and an antenna is to be used, then locate the
antenna outside the cabinet.
2. Connect the antenna (optional, required when using
thermostats) to the controller (2.1), and attach it
to the wall using a wall screw and plug (2.2) or the
adhesive strip (2.3).
3. Connect additional equipment, such as actuator(s),
circulation pump(s), temperature sensors etc, and
secure them with cable clamps.
The outdoor temperature sensor can be connected
to either the controller or a thermostat (requires
antenna A-155).
4. Check that all wiring is complete and correct:
• Actuator(s)
• Heating/cooling switch
• Circulation pump(s)
• Temperature sensor(s)
5. Ensure that the 230 V AC compartment of the
controller is closed and the fixing screw is tightened.
6. Connect the power cable to a 230 V AC wall socket,
or if required by local regulations, to a junction box.
Thermostat registration (requires
antenna A-155)
C
aution
!
If communication difficulties exist, Uponor
recommends relocating the antenna to a more
optimal position, and not installing Uponor
radio sources to close to each other
(at
least 40 cm apart) , for solving exceptional
problems.
C
aution
!
The DIP switches in public thermostat
T-163 must be set before the thermostat is
registered.
C
aution
!
The DIP switch in the public thermostat T-163
must be set to one of the available functions,
otherwise it cannot be registered.
C
aution
!
Do not attempt to connect Uponor Smatrix
Base thermostats to the controller. They are
not suited for each other, and they may get
damaged.
N OT E !
If the outdoor sensor is placed to far
away from the reference room, a separate
thermostat can be used to register the
outdoor sensor.
7. Connect optional external sensor.
8. Set the DIP switch on public thermostat T-163.
Function Switch
Room thermostat
1 2 3 4
ON DIP
Room thermostat with outdoor temperature
sensor
1 2 3 4
ON DIP
Remote sensor
1 2 3 4
ON DIP
9. Insert batteries into the thermostats.
10. Set time and date on thermostats (digital
thermostat T-168 only).
11. Select thermostat control mode (settings menu 04 ,
in digital thermostats only). Default: RT (standard
room thermostat).
RT = Room temperature
RFT = Room temperature with external floor sensor
(limitations does not affect the operation of
the Move controller, when not integrated to
a Wave controller)
RS = Remote sensor
RO = Room temperature with remote outdoor
sensor
12. Register the thermostat and outdoor sensor ( see
next page ).
13. Setup the system ( see page 10 ).