Uponor c56, Инструкция по установке и эксплуатации

Страница: 6 / 56

Preface
The Uponor Control System Installation and Operation Manual
describes how to install and operate the components of the
system.
Conventions used in this manual
The following symbols are used in the manual to indicate special
precautions when installing the Uponor Control System:
WARNING
Risk of injury.
Ignoring warnings can cause injury or damage
components.
CAUTION
Ignoring cautions can cause malfunctions.
Safety measures
Read and follow the instructions in the Installation and
Operation Manual.
Installation must be performed by a competent person in
accordance with local regulations.
It is prohibited to make changes or modifi cations not specifi ed
in this manual.
All power supply must be switched off before starting any
wiring work.
Do not use water to clean Uponor Control System components.
Do not expose the Uponor Control System to fl ammable
vapours or gases.
We cannot accept any responsibility for damage or breakdown
that can result from ignoring these instructions!
Power
WARNING
The Uponor Control System uses 50 Hz 230 V AC power.
In case of emergency, immediately disconnect the
power.
Limitations for radio transmission
The Uponor Control System uses radio transmission. The
frequency used is reserved for similar applications, and the
chances of interference from other radio sources are very low.
However, in some rare cases, it might not be possible to
establish perfect radio communication. The transmission
range is suffi cient for most applications, but each building
has different obstacles affecting radio communication and
maximum transmission distance. If communication diffi culties
exist, Uponor can support the system with accessories, such as
repeaters, for solving exceptional problems.
Technical constraints
• To avoid interference, keep installation/data cables
away from power cables for more than 50 V.
• The electrical circuits of the boiler and the pump
must be protected by a circuit breaker rated at 6 A or
below.
Disposal
The Uponor Control System consists of various recyclable
components. Uponor would be grateful if the components
(batteries, plastics, and electric or electronic parts) are sorted
and disposed of at a suitable recycling centre.
STOP
STOP
6
U P O N O R C O N T R O L S Y S T E M – I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
UK English