Uponor c56, Инструкция по установке и эксплуатации

Страница: 22 / 56

4.4 Install Thermostat T-54 Public and T-55
Attach to wall
Uponor Thermostat T-54 Public and T-55 can be attached to a
wall with screws or adhesive strips, as shown in the illustration
below.
To avoid unnecessary alarms, make sure to fasten the
cover correctly on Uponor Thermostat T-54 Public.
4.5 Test communication
Uponor recommends testing the communication between the
thermostats and the controller after installation.
The illustration below shows the location of the test button of
the controller and the registration buttons of Thermostat T-54
Public, T-55 and T-75.
To test communication between controller and all thermostats:
1 Press and release the Test button. The test and channel
LEDs with registered thermostats comes on.
2 Using a pointed instrument, gently press the registration
button of each registered thermostat.
• Communication OK: LEDs for the channels registered to
the thermostat go off.
• No communication: LEDs for the channels registered to
the thermostat stay on.
3 To exit test mode, press the Test button.
When two thermostats are connected to the same channel, each
thermostat must be tested separately.
4.6 Complete controller installation
To complete the Uponor Controller C-55/56 installation:
1 Check the entire installation:
• Check that the antenna is correctly installed
• Check that the thermostats have power
2 Close all controller and thermostat covers.
3 Complete the installation report in this manual.
4 Give the manual and all system information to the end user.
2 2
U P O N O R C O N T R O L S Y S T E M – I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
UK English