Unox XC535, Инструкция и технические данные

Страница: 4 / 42

UNO
R
UNO
R
In the front, you use the appropriate auto-drilling
screws ( supplied with the hood ).
Place the appliance respecting the safety standards
in force that you find here following described.
Place the appliance so that its back and lateral sides
can be easily reached in order to make the electrical
connections and provide the needed service.
The appliance is not suitable for built-in installation
The appliance is not suitable for built-in installation
and side by side positioning.
and side by side positioning.
If the appliance is placed near walls, dividers, kitchen
cabinets, decorated edges, etc., it is recommended
that this be of non combustible material.
Otherwise, they must be coated with non combustible
thermal insulating material and you must be very
respectful of the fire prevention standards.
3.3
REMOVAL OF THE PROTECTIVE FILM
Carefully remove all the protective film from the
external walls of the appliance. Pay attention not to
leave any rest of glue on the sides. If there should
be any residue, please remove it with an appropriate
solvent.
4. INSTALLATION
4.1 ELETTRICAL CONNECTION
a- The connection to the electrical power supply
system must be done according to the standard
in force.
The installer is responsible of the correct electrical
connection and of the compliance of the safety
standards.
Before connecting the appliance, make sure that :
- the voltage and the frequency correspond to those
stated on the data plate of the appliance.
- the outlet has the grounding and that is able to
support the charge requested by the appliance
indicated on its data plate.
- the outlet fits the type of the plug installed on the
appliance (Schuko 16 A)
Avoid to use extensions and multiple outlets.
The appliance must be placed so that the connection
plug can be easily reached.
Place between the appliance and the network an
omni-polar switch so that it is easily accessible after
omni-polar switch so that it is easily accessible after
the installation. The contacts of this switch must have
a minimum opening distance of 3 mm and the switch
must have an appropriate input. We advise the use of
a magneto-thermal differential switch
magneto-thermal differential switch.
When the appliance is working the power supply
voltage must not diverge from the value of the
nominal voltage, written on the technical data plate,
by more than ± 10%.
The connection to the electrical power must be done
through a Schuko plug of 16 A.
Place the input cable in a way that no point exceeds
the environment’s temperature for more than 50°C.
b- The appliance must be connected to the round line
of the network
.
Moreover, the appliance must be
included in an equipotential system
equipotential system
whose efficiency must be properly
checked according to the current
law.
This connection must be done
between the different appliances
using the terminal marked with the symbol:
The equipotential conductor must have a minimum
section of 10 mmq.
4.2 CONNECTION TO THE OVEN
To connect steam condenser to the oven, please
operate as follows:
a- Electrical Connection
1- Remove the back of the oven
2- Connect the control cable of the hood to the power
board by connecting it to the proper connector (see
the picture)
3- Fix the cable fastener your find on the cable of the
hood in the special slit you find on the bottom of the
ENGLISH
4