INSUHC0116
5
ELECTRICAL CONNECTION & OPERATION
WITH A BUILT-IN ELECTRONIC THERMOSTAT
HOW TO SET THE TEMPERATURE
You can change the temperature by increasing (top button) or decreasing (bottom button) the set point. The temperature set point will increase
or decrease by increments of 0.5 °C (or 1 °F) each time you press down a button. If you hold down the button, the temperature will quickly scroll
through, allowing a faster and more efficient setting. Once the temperature is set, release the button.
PRECISE ELECTRONIC CONTROL
A chrono-proportional electronic thermostat controls this unit with a high degree of accuracy in order to minimize temperature differences and
increase your comfort level. It allows very stable temperature and ensures uniform comfort. It also keeps the casing at a low temperature, making
it more secure.
The chrono-proportional electronic thermostat entirely regulates the unit by increasing or decreasing the heating cycle percentage according to
the selected temperature. Please note that the unit becomes warmer if the heating demand is higher and that it remains mildly warm when the
demand is lower.
N.B. If the unit is set on high or if it is not functioning at all, the temperature gage of the thermostat sensor cannot
take a precise reading. However, the reading becomes extremely precise once the heating level has stabilized.
Therefore, uniform convection increases the precision of the thermostat.
In order to obtain a precise and optimal ambient temperature reading, the unit must operate on a regular basis, i.e. without significant temperature
variation for at least an hour. (This amount of time increases if a temperature change of more than 4 degrees is requested. Add approximately 15
minutes for every degree above 4).
ELECTRONIC WALL THERMOSTAT CONTROL
An electronic wall thermostat equipped with a proportional tension variation that maintains a precise temperature is preferable thus increasing your comfort level.
OPERATION
Unit
Electric
box
Connector (marette)
Green wire
L1
L2
THIS PRODUCT MUST BE CONNECTED BY
A QUALIFIED ELECTRICIAN, ACCORDING
TO THE ELECTRICAL AND BUILDING CODES
EFFECTIVE IN YOUR REGION.
This unit must be connected by a certified electrician. Connect the
bare wire (ground) to the green wire. Connect wires from the electric
box to the unit’s supply leads.
ELECTRICAL CONNECTION
STANDARD MODELS
(FIXED CONNECTION)
MODELS WITH 120 V PLUG
(RESIDENTIAL OUTLET)
THIS UNIT IS EQUIPPED WITH A THREE-WIRE GROUNDING
TYPE AC PLUG:
- For safety reasons, the plug can only be inserted into an outlet with
grounding. If you are unable to insert the plug into the outlet, con-
tact your electrician to have a suitable receptacle installed. Do not
condemn the ground prong of the plug.
-
This heater must be plugged into a dedicated 120 V circuit. The
addition of other electrical appliances on this circuit may trip
the circuit breaker.
- Plug the cord of the heater directly into the wall outlet (do not use
an extension cord).