1. Ensure the control unit in not in charge mode by removing it from wireless charging pad
2. Push and keep pushed for 8 seconds the command button (8)
3. During pairing function the command indicator LED (9) blinks in a red color very fast. It starts slowly
blinking in a red color as soon as the RF remote controller is correctly paired with the control unit.
CONNECT FUNCTION
This function enables the comunication betweeen RF remote controller and LED control unit and shall be
performed after every control unit’s charge or when the RF remote controller exits from the covered area of
10 meters far from the control unit. The need of a new connection is showed by no light of the command
indicator LED (9).
1. Ensure the control unit in not in charge mode by removing it from wireless charging pad
2. Quickly push and release the command button (8)
3. Command indicator LED (9) quickly blinks during connection, and it slowly blinks in a red color to confirm
the Bluetooth remote controller is corretly connected to the control unit.
USE OF REMOTE CONTROL
1. Quickly push and release command button (8) to turn ON the device
2. Push for 1sec and release command button (8) to turn OFF the device
3. Quickly push and release command button (8) to adjust brightness intensity among minimum, medium
and maximum levels
BATTERY CHARGING
1. Connect the wireless charging pad to the charger by using the USB cable.
2. Insert the charger into a wall socket 220V~50 Hz / 110V~60 Hz.
3. Place the control unit with the front surface in contact with the wireless charging pad. Please verify the
control unit is placed in the middle of the wireless charging pad surface
4. A single sound confirms the control unit is properly placed on the wireless charging pad. If the sound is
not emitted, remove the control unit from wireless pad and try to place it in the proper position.
5. A serie of 4 sounds informs the control unit is not properly placed on the wireless charging pad or the
battery is already charged
6. The following colors of charge status indicator LED (6) will indicate the charge status: RED: Charge mode.
The battery is charging - GREEN: Charge completed. The battery is ready for use. 10min after the full charge
is reached, the GREEN light turns off.
USING THE DEVICE
1. Connect the cable of the headlamp to the control unit using the dedicated connector (5)
2. Turn on the device by pressing the power button (1). The multicolor LED bar (2) shows for two seconds
the brightness setting in use
