3. The multicolor LED bar (2) indicates the charge status: when the residual battery charge drops below
10% the indicator LED will become orange, while when the residual charge drops below 5% the light will
start flashing
4. Adjust the luminous intensity by acting on the adjustment buttons (3) and (4) on top of the controller: a
short pression causes the passage through five discrete steps. By keeping pushed buttons (3) or (4) a fine
adjustment of light intensity is allowed: release the button as soon as the desired brightness is reached
5. The multicolor LED bar (2) present on the front part of the controller will indicate in green color the level
of luminous intensity set during brightness adjustment
6. To turn off the device push the button (1). This device records the last brightness setting and keeps it
stored for the following use
UV FILTER
The filter UV525 enables shielding the ultraviolet radiation emitted by the LED that could interfere with
some work processes. The support is mounted on the lighting head by a slight pressure until it remains in
position. The movement of the ring nut allows the filter to be removed from the light beam without having
to unclip the support from the lighting head.
Should the filter support be excessively slack after being mounted on the spotlight, operate the clamping
screw gently.
CLEANING INSTRUCTIONS
Disconnect the cable from the lighting head before cleaning. Do not proceed with the cleaning while the
controller is connected to the charger.
Use a microfibre cloth to clean the lenses. The control unit can be cleaned with a soft cloth soaked in a
gentle disinfectant solution. Do not soak or spray any component with disinfectants and other liquids. The
LED lighting system cannot be sterilised in an autoclave. Make sure that the lighting system is completely
dry before use.
RADIO FREQUENCY DEVICE CERTIFICATION
FCC - FEDERAL COMMUNICATIONS COMMISSION
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
WARNING: Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
