universalblue UBLAV2702-21, Руководство пользователя

Страница: 61 / 93

61
ADJUSTING THE WATER SOFTENER
The water softener is designed to remove minerals and salts from
the water, which would have an adverse effect on the operation of the
appliance. The higher the content of these minerals and salts, the
harder the water. The softener should be adjusted according to the
hardness of the water in your area.
To adjust the descaler, follow the instructions below:
The amount of salt can be adjusted from H0 to H7.
No salt is required at the set value H0.
To adjust the descaler, follow the steps below:
1.
Find out the tap water hardness value. Your water authority will be
able to help you with this.
2. The set value can be found in the water hardness table below.
3. Once adjusted, close the dishwasher door.
4. Press the "Power" button.
5. Press and hold the "Delay" button and press the "Program" button
for 5 seconds. The device will beep once and the indicator 'H' will
appear on the display (H4 is the factory default).
6. To change the value, press the "Delay" button as many times as
necessary until the desired value is set. Each time the button is
pressed, a level is increased. When the value reaches H7, pressing
H0 again jumps the display.
7. Press the " Program " button to store the selected value.
Water hardness
Mmol/l
Value to set in the
dishwasher
Hardness
grades
Range
0-8 Soft 0-1.1 H0
9-10 Soft 1.2-1-4 H1
11-12 Medium 1.5-1.8 H2