12
When this step is complete, remove the rubber gloves
to prevent ink contamination with the external parts
of the coder.
While handling the ink rolls, solvents will evaporate from
the rolls very rapidly at normal room temperatures. The
Inking System Cover must be replaced quickly to prevent
solvent loss.
A slight wiggling action or rotation of the Drive Wheel will
help overcome the resistance caused by contact with the
rubber Bearer Ring on the Print Drum. The tops of the
stainless pins will be flush with the top of the Drive Wheel
when seated properly.
Hold the Drive Wheel Cover and Inking System
Cover in place.
8 - Install the ink roll on the Ink Roll Axle by aligning the end
of the rod or pencil with the end of the axle and pushing
the roll onto the axle.
9 -Immediately replace the Inking System Cover “D” by
carefully guiding the cover over the Transfer Roll “G”.
Try not to let the cover contact the surface of the Transfer
Roll to prevent scratching. Make sure the Cover is
seated properly against Baseplate “F”.
10 -Replace the Knurled Drive Wheel “E” by aligning the 3
small holes with the 3 stainless drive pins on the top of
the Transfer Roll “G” and pressing the Drive Wheel onto
the Transfer Roll.
11- Replace the Drive Wheel Cover “B” and rotate it into
position with the flat edge directly facing the Print Drum.
FIGURE 16
FIGURE 17
FIGURE 18
QUICK START
FIG
URE
19
D
G
F
G
E
B
