10
The ink roll you install on the coder must be properly pre-inked.
If your coder was supplied with a dry XF
Neoprene ink roll, refer to page 9 for inking instructions.
Warning: Non-Porous inks contain flammable solvents. Do not smoke or handle these rolls in the
presence of sparks or open flames. Inks will also stain clothing, furniture, carpeting and your hands.
Rubber gloves should be worn during the following procedures.
INSTALLING THE PRE-INKED ROLL
This moves the Ink roller axle away from the Transfer
Roll and enables the ink roll to be installed without
interference with the Transfer Roll during reassembly of
the inking system.
The Cover Retaining Knob holds the entire inking system
together and other parts may fall free from the coder if
not held securely when this knob is removed.
The Knurled Drive Wheel Cover has a very loose fit.
Note that one edge of the Drive Wheel Cover is flat and
is aligned towards the print drum. During reassembly,
this flat edge must be replaced in the same position.
Rollers that have been pre-inked at the factory are normally slightly oversaturated with ink to compensate for
potential solvent loss during shipping and storage. If you received a pre-inked ink roll with your coder, it is
important to examine the roll prior to installation.
The ink roll should be thoroughly saturated with ink but not
dripping wet.
Excess ink can be easily removed by lightly rolling the ink roll across a clean piece of absorbent
paper.
1 - To install the pre-inked roll, first turn the Ink Roll
Eccentric Adjusting Knob “A” to the “MIN” position.
2 - While holding the Drive Wheel Cover “B” in place,
remove the Knurled Cover Retaining Knob “C” by
turning it counterclockwise.
3 -Hold Inking System Cover “D” in place and remove
Knurled Drive Wheel Cover “B”.
FIGURE 9
FIGURE 10
QUICK START
FIGURE 11
A
B
C
B
D
