MRF-260 B
ASE
S
TATION
Page 12
Frequently Asked Questions
Can I use flasher/emitters that I have already installed in the sys-
tem to connect to the MRF-260?
Yes, the flashers are compatible if they use 3.5mm mono mini plugs with
the same polarity (Tip is data, sleeve is ground).
I’m getting inconsistent operation regardless of flasher level or
position.
Some components are easily overloaded with IR from nearby flashers.
Prevent IR from affecting the problem component from other flashers or the
front panel blaster by setting the device to a specific IR Line Output instead
of ALL, then adjust the Line Output.
I have a row of identical TVs. I’ve correctly set the flasher outputs
using the Editor software, yet when I send a command to one of
them, the TV next to the selected TV also responds. How do I stop
this?
First, check the RF ID#, if the RF ID# is set to 0, IR routing does not work.
Second, set the RF ID# from 1-9 or A-F on both the remote control and the
rear of the MRF-260. Third, check that the flasher level is set to the mini-
mum necessary. Fourth, check that the emitter is facing the component.
Specifications
Power Supply: 9V 300mA
IR Flasher Line Outputs: 3.5mm Mono Mini Jack
RF Frequency: 418MHz
