Rev. 6/6/19
INSTALLATION INSTRUCTIONS
BLC48 LINEAR HIGH BAY LUMINAIRE
14043600 REV 3
Page 2
SAFETY WARNINGS
IMPORTANT SAFETY INFORMATION
Follow information on label & instructions regarding installation near combustible materials, insulation, and building
materials & in Dry or Wet locations. Do not install in areas exposed to combustible vapors or gases.
This product must
be installed by a person familiar with construction and operation of the product and the hazards involved, in
accordance with the applicable installation. Be sure to ground product to avoid potential electrical shock or
other potential hazard.
Use of accessory equipment not recommended by the manufacturer or installed inconsistent
with instructions may cause an unsafe condition. Do not completely or partially block light emerging from product, as this
could cause an unsafe condition. Do not allow other items to come into contact with the product, as this may cause an
unsafe condition.
WARNING:
This product may contain chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash your hands after installing, servicing, handling, cleaning, or
otherwise touching this product. This device complies with FCC CFR Title 47 Part 15, Class A requirements for EMI/RFI.
Step 1: Installation of Security Tether
Push steel tie through slot at either end of fixture.
Step 3: Add Mounting Clips
Install wire guard mounting clips at each of the four corners.
Step 4: Tighten Mounting Clips
Snap the mounting clip to the wire guard, then position as shown and
tighten thumb screw.
Step 2: Installation of Diffusor
Install diffusor (if applicable) by wrapping around fixture body leaving both
ends of the steel tie exposed.
Step 5: Complete Installation
Complete installation of security tether. Insert tag end into grip and pull to
form a loop. Leave enough slack for cleaning and possible service.
STOP
Before you begin.
Read these instructions completely & carefully.
WARNING
Risk of electrical shock.
Disconnect power before servicing or installing luminaire.
!
WARNING
Risk of injury or damage.
Mount only to a mechanically sound surface; All
fixtures must be connected to a grounded, three-wire supply; All electrical
connections must be capped with UL listed wire connectors rated 600V or
higher; If supply wires are located within three inches of the LED driver, use
wire rated for at least 90°C; Consult qualified electrician before installing.
!
WARNING
Risk of injury or damage.
Luminaire will fall if not installed properly. Follow
installation instructions, NEC and local codes and best trade knowledge.
!
WARNING
!
Risk of injury.
Wear safety glasses and gloves during installation and servicing.
Fig. 1 a
Fig. 1 b
Fig. 2
Fig. 4
Fig. 3
Fig. 5
WIRE GUARD INSTALLATION
