TROUBLESHOOTING
PROBLEM:
LED does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
alkaline batteries (see page 7).
PROBLEM:
LED blinks when you press a key, but home
entertainment component does not respond.
SOLUTION: Make sure you are aiming the Millennium 4 at
your home entertainment component and that
you are within 15 feet of the component you are
trying to control.
PROBLEM:
The Millennium 4 does not control home enter-
tainment components or commands are not per-
forming properly.
SOLUTION: Try all listed codes for the component brand
being set up. Make sure all components can be
operated with an infrared remote control.
PROBLEM:
TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some combo
units may require both a TV code and a VCR
code for full operation (see page 16).
PROBLEM:
No volume on a second TV.
SOLUTION: Follow instructions in
Changing Volume Lock
(see page 31).
PROBLEM:
CH+
,
CH –
, and
LAST
do not work for your
RCA TV.
SOLUTION: Due to RCA design (1983-1987), only the original
remote control will operate these functions.
PROBLEM:
Changing channels does not work properly.
SOLUTION: If original remote control required pressing
ENTER to change channels, press
ENTER
on the
Millennium 4 after entering a channel number.
PROBLEM:
Tried “Search Method” and still could not find a
working code.
SOLUTION: Try the “Search Method” again after clearing out
the device key as follows: Press and hold
ENTER
until red light blinks twice, then release. Next
enter
9
-
9
-
2
. Then press and release the device
key to be cleared twice.
PROBLEM:
Remote control does not turn on Sony or Sharp
TV/VCR Combo.
SOLUTION: For power on, these products require program-
ming TV codes on the Millenium 4. For Sony, use
TV code 0000 and VCR code 0032. For Sharp, use
TV code 0093 and VCR code 0048.
33
Millennium 4 Mnl M4090 7/23/99 9:34 AM Page 33
