Universal Audio Apollo Twin MkII, Руководство по оборудованию

Страница: 13 / 38

Apollo Twin MkII Hardware Manual Quick Start 13
Quick Start
Apollo Twin MkII hardware and software installation and setup consists of these steps:
1. Hardware Setup : Connect and power the Apollo Twin MkII hardware
2. Software Setup : Download and install the Apollo Twin MkII software
3. Connect to Input Sources and Monitor System
4. Setting Hardware I/O Levels : Learn how to adjust input and output levels
Hardware Setup
Select a Suitable Location
• Locate Apollo Twin MkII on a flat surface so its feet will maintain airflow beneath the
unit.
• The location should be sturdy enough to securely hold its weight and withstand
the pressure of operating the top panel controls.
• Leave enough room behind the unit for connected cabling.
• Do not block the cooling vents on the bottom or sides of the unit.
Connect to Computer and Power
Caution: Before powering Apollo Twin MkII on or off, lower the volume of the
monitor speakers (if connected) and remove headphones from your ears.
1. Connect one Thunderbolt cable (not included) between Apollo Twin MkII and the
host computer.
2. Connect the included power supply to an AC outlet (Apollo Twin MkII cannot be
bus powered).
3. Connect the locking power supply to the rear panel of Apollo. Align the two tabs
on the power cable's connector to the notches on the input, then rotate the barrel
to prevent accidental disconnection.
Important: After ensuring the locking barrel tabs are aligned with the chassis slots
and the barrel is fully inserted, rotate the barrel to secure the connector.
4. Apply power to Apollo Twin MkII using the rear panel's power switch. Apollo Twin
MkII is now ready for Software Setup .
12VDC
1. Align Tabs
2. Rotate to Lock