Unitronics Vision 230, Руководство по установке

Страница: 2 / 9

Vision™ OPLC™ Models V230/260/280/290 (Non-color Screens)
2 Unitronics
Operand Types Memory Bits 4096 │ Memory Integers, 16-bit, 2048 │ Long Integers, 32-bit,
256 │ Double Word, 32-bit unsigned, 64 │ Memory Floats, 32-bit, 24 │
Timers, 32-bit, 192 │ Counters, 16-bit, 24
Additional product documentation is in the Technical Library, located at www.unitronics.com .
Technical support is available at the site, and from support@unitronics.com.
Kit Contents
Vision controller Programming cable + RS232 adapter
Mounting brackets (x4) Grounding hardware
3 pin power supply connector Rubber seal
5 pin CANbus connector Extra set of keyboard slides, according to model
CANbus network termination resistor Unitronics’ Setup CD
Alert Symbols and General Restrictions
When any of the following symbols appear, read the associated information carefully.
Symbol
Meaning Description
Danger The identified danger causes physical and property damage.
Warning The identified danger could cause physical and property damage.
Caution Caution Use caution.

Before using this product, the user must read and understand this document

All examples and diagrams are intended to aid understanding, and do not guarantee operation
Unitronics accepts no responsibility for actual use of this product based on these examples

Please dispose of this product according to local and national standards and regulations

Only qualified service personnel should open this device or carry out repairs
Failure to comply with appropriate safety guidelines can cause severe injury or property damage

Do not attempt to use this device with parameters that exceed permissible levels

To avoid damaging the system, do not connect/disconnect the device when power is on
Environmental Considerations

Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration, in
accordance with the standards given in the product’s technical specification sheet

Ventilation: 10mm space required between controller’s top/bottom edges & enclosure walls

Do not place in water or let water leak onto the unit

Do not allow debris to fall inside the unit during installation

Install at maximum distance from high-voltage cables and power equipment