Unitron Z12, Руководство пользователя

Страница: 9 / 18

Z12 ZOOM STEREO MICROSCOPE
UNITRON
73 Mall Drive, Commack, NY 11725 • 631-543-2000 • www.unitronusa.com 8
DETAILED ASSEMBLY -
continued
Mount the Viewing Head (Fig. 5-6)
Loosen the lock screw
①
on the front of the microscope
body with the 3mm mm hex wrench.
With the eyepiece tubes
②
facing forward (as shown in
Fig. 6), carefully slide the dovetail
③
(Fig. 5) on the bottom
of the viewing head
④
(Fig. 5) onto the dovetail mount on
the top of the microscope body by aligning the orientation
groove
⑤
with the orientation pin
⑥
of the microscope
body. Make sure it is seated properly (it should be level and
not wobble), then tighten the lock screw.
Install the Eyepieces (Fig. 6)
Remove the eyetube caps
⑦
and insert the eyepieces
⑧
into the eyepiece tubes
②
.
Lock in the eyepieces by tightening the thumbs screws
⑨
on each eyepiece tube.
Mount/Unmount the Eyepiece Reticle (Fig. 7)
To mount the reticle: unscrew the mounting ring
①
from
the eyepiece by turning it counterclockwise.
Clean the reticle
②
and insert it into the mounting ring with
the inscription side as shown.
Screw the mounting ring back onto the eyepiece.
To remove the reticle: unscrew the mounting ring from the
eyepiece, then carefully take out the reticle and wrap it in
clean, soft, lint-free paper for storage.
Screw the mounting ring back onto the eyepiece.
Install the Stage Insert Plate (Fig. 8)
Gently push the stage insert plate
①
with the edge tilted
toward the spring on the inside of the hole in the base and
set it into place.
To remove the stage insert plate, press down with one finger
near the spring – it will pop up on the opposite side and you
can then lift it out.
①
⑤
Fig. 5
③
Fig. 6
Fig. 7
Fig. 8
①
②
④
⑥
⑦
⑧
⑨
Inscription Side
①
②