Control connections
Version: 2022 / V2
Page: 44
BAMOCAR-PG-D3-700-100/160
4.12
Rotor position sensor connection with BL tacho
Only with BAMOCAR-PG- D3-BL
3 rotor position encoder signals
(Hall sensors) for commutation.
With or without brushless
tachogenerator.
The rotor position sensor is galvanically
connected to device zero (GND).
Supply voltage 15 V from servo.
Adaptation adapter if the tachometer
voltage at nominal speed is greater than
10 V~.
For lower tacho voltages
X7: Connect pins 1, 9 and 11.
Connect speedometer center to X7:1.
Only use motors with rotor position encoders (bl) which have been approved by the manufacturer.
Connector
X7
14-pin Tyco type connector
Connecting cable
12 x signal conductors,
supply lines,
2 x temperature cores
min. cross-section 0.25 mm
For link chains use appropriate cables!
Cable length
for >25 m the cross-section of the cable used must be increased by one
grade
Shield connection
across connector X7
connect the shield to the
connector housing
across the motor connector
connect the shield to the
connector housing
Setting parameters
see software Manual NDrive
