UnitedPower IG3600S, Инструкция по эксплуатации

Страница: 9 / 17

6. STARTING THE ENGINE
Operating this generator less than 3 feet (1 meter) from
a building or other obstruction can cause overheating
and damage the generator. For proper cooling, allow
at least 3 feet (1 meter) of empty space above and around
the generator. Refer to SAFE OPERATING PRECAUTIONS
on page 1 and perform the pre-operation cleck(see page
5). Refer to AC OPERATION (see page 7 ) or DC OPERATION
(see page 33 ) for connecting loads to the generator.
1.Make sure that all appliances connected to the
generator are turned off. The generator may be hard to
start if a load is connected.
2.Turn the fuel valve lever to the ON position.
3.Make sure the Eco-Throttle switch is in the OFF position,
or more time will be required for warm-up.
4. T0 start a cold engine, pull the choke knob out to the
CLOSED position.To restart a warm engine, leave the
choke knob in the OPEN position.
5. Turn the engine switch to the START position, and hold
it there until the engine starts. When the engine starts,
release the key, allowing the switch to return to the
ON
position. If the engine fails to start within 5 seconds,
release the key, and wait at least 10 seconds before
operating the starter again.
STARTING THE ENGINE
6.If the choke knob was moved to the CLOSED position to
start the engine, gradually push it to the
OPEN position
as the engine warms up.
7.If you wish to use the Eco-Throttle system, turn the
Eco-Throttle switch to the ON position after the engine has
warmed up for 2 or 3 minutes.
Manual starting:
1.Make sure that all appliances connected to the generator
are turned off.
2.Turn the fuel valve lever to the ON position.
3.To start a cold engine, pull the choke knob out to the
CLOSED position.
To restart a warm engine, leave the choke knob in the
OPEN position.
4.Turn the engine switch to the ON position.
5. Pull the starter grip lightly until you feel resistance,
then pull briskly in the direction of the arrow as shown.
6. If the choke knob was moved to the CLOSED position
to start the engine, gradually push it to the OPEN position
as the engine warms up.
7. If you wish to use the Eco-Throttle system, turn the
Eco-Throttle switch to the ON position after the engine
has warmed up for 2 or 3 minutes.
To prevent a possible fire, keep the generator at least 3
feet (1 meter) away from building walls and other
equipment during operation. Do not place flammable
objects close to the engine.
Do not allow the starter grip to snap back against the
generator. Return it gently to prevent damage to the
starter.
Direction to pull
Recoil Starter
CHOKE KNOB
ECO.THROTTLE SWITCH
NOTICE
FUEL VALVE LEVEL
Using the electric starter for more than 5 seconds at a
time will overheat the starter motor and can damage it.
Do not leave the engine switch in the ON position when
the generator is not operating as the battery will
discharge. Turn the engine switch to the OFF position
when not in use.
NOTICE
ECO.THROTTLE SWITCH
CHOKE KNOB
NOTICE
ENGINESWITCH
6