UnitedPower IG3600S, Инструкция по эксплуатации

Страница: 8 / 17

5.PRE-OPERATION CHECK
ENGINE OIL
SAE Viscosity Grades
Check the oil level
BEFORE EAC HUSE
with the generator on
a level surface and the
engine stopped.
Use 4-stroke motor oil
that meets or exceeds
the requirements for
API service classification SJ or later (or equivalent).
Always check the API SERVICE label on the oil container
to be sure it includes the letter SJ or later (or equivalent).
SAE 10W-30 is recommended for general, all-
temperature use. Other viscosities shown in the chart
may be used when the average temperature in your area
is within the indicated range.
1. Open the left side maintenance cover.
2. Remove the oil dipstick and wipe the dipstick clean.
3. Check the oil level by inserting the dipstick into the
filler neck without screwing it in.
4. If the level is low, fill to the upper limit of the oil filler
neck with the recommended oil.
5. Close and latch the left side maintenance cover.
Stop the engine and keep heat, sparks, and flame away.
Handle fuel only outdoors.
Wipe up spills immediately.
Refuel in a well-ventillated area with the engine stopped.
If the engine has been running, allow it to cool first.
Refuelcarefully to avoid spilling fuel. Do not fill above the
fuel strainer shoulder. After refueling, tighten the fuel
tank cap securely.
Never refuel the engine inside a building where gasoline
fumes may reach flames or sparks. Keep gasoline away
from appliance pilot lights, barbecues, electric appliances,
power tools, etc.
Spilled fuel is not only a fire hazard, it causes environmental
damage.
Wipe up spills immediately.
Fuel can damage paint and plastic. Be careful not to spill
fuel when filling your fuel tank. Damage caused by
spilled fuel is not covered under warranty.
FUEL RECOMMENDATIONS
This engine is certified to operate on regular unleaded
gasoline with apump octane rating of 86 or higher.
Never use stale or contaminated gasoline or an
oil/gasoline mixture. Avoid getting dirt or water in the
fuel tank.
After refueling, reinstall the fuel tank cap securely.
You may use regular unleaded gasoline containing no
more than 10% Ethanol (E10) or 5% Methanol by volume.
In addition, Methanol must contain cosolvents and
corrosion inhibitors.
Use of fuels with content of Ethanol or Methanol greater
than shownabove may cause starting and/or performance
problems. It may also
damage metal, rubber, and plastic parts of the fuel system.
Engine damage or performance problems that result from
using a fuel with percentages of Ethanol or Methanol
greater than shown above are not covered under warranty.
Fuel tank Cap
H
L
UPPER LIMIT
REFUELING
With the engine stopped, check the fuel level gauge.
Refill the fuel tank if the fuel level is low. Refuel carefully
to avoid spilling fuel. Do not fill above the maximum fuel
level.
Gasoline is highly flammable and explosive.You can be
burned or seriously injured when handling fuel.
Temperature Range of Expected Use
5