UnitedPower IG3600S, Инструкция по эксплуатации

Страница: 13 / 17

6 .
Visually inspect the spark plug. Replace it if the
electrodes are worn or if the insulator is cracked, chipped,
or fouled.
7.Measure the spark plug electrode gap with a wire-type
feeler gauge.
Correct the gap, if necessary, by carefully bending the
side electrode. The gap should be: 0.028 0.031 in
(0.70 0.80 mm)
8.
Check that the spark plug sealing washer is in good
condition, and thread the spark plug in by hand to prevent
cross-threading.
9. Afterthesparkplugisseated,tightenwithasparkplu
gwrenchto compress the washer.
If installing a new spark plug, tighten 1/2 turn after the
spark plug seats to compress the washer. If reinstalling a
used spark plug, tighten 1/8 1/4 turn after the spark plug
seats to compress the washer.
10.Reinstall the spark plug inspection cover and tighten
the cover screw.
11. Close and latch the left side maintenance cover.
3.Remove the spark plug cap
4.Clean any dirt from around the spark plug base.
5.Use a spark plug wrench to remove the spark plug.
SPARK PLUG SERVICE
In order to service the spark plug, you will need a spark
plug wrench (commercially available). Recommended
spark plugs: W16EPR-U (DENSO) BPR5ES (NGK) To ensure
proper engine operation, the spark plug must be
properly gapped and free of deposits.
If the engine has been running, let it to cool before
servicing the spark plug.
1. Open the left side maintenance cover.
2. Loosen the cover screw and remove the spark plug
inspection cover.
SPARK PLUG WRENCH
0,7-0,8 mm
(0,028-0,031 pouces)
10
SPARK ARRESTER SERVICE
1.Remove the exhaust tail pipe and spark arrester
2.Use a brush to remove carbon deposits from the spark
arrester screen
3.Reinstall the spark arrester