-2-
This manual describes the installation and operation of the Vogelzang, VG5780 wood heater. This heater meets the 2020
U.S. Environmental Protection Agency’s crib wood emission limits for wood heaters sold after May 15, 2020. Under specific
test conditions this heater has been shown to deliver heat at rates ranging from 12,293 to 26,386 Btu/hr. This heater
achieved a particulate emissions rate of 1.3 g/hr when tested to method ASTM E2779-10 (*and an efficiency of 72%).
•
IMPORTANT: Read this entire manual before installing
and operating this product. Failure to do so may result
in property damage, bodily injury, or even death.
Proper installation of this stove is crucial for safe and
efficient operation.
•
Install vent at clearances specified by the vent
manufacturer.
• Do not connect the pellet vent to a vent serving any
other appliance or stove.
•
Do not install a flue damper in the exhaust venting
system of this unit.
•
Use of outside air is not required for this unit.
•
Contact your local building officials to obtain a
permit and information on any additional installation
restrictions or inspection requirements in your area.
• Do not throw this manual away. This manual has
important operating and maintenance instructions
that you will need at a later time. Always follow the
instructions in this manual.
•
This appliance is designed for the use of pelletized fuel
that meet or exceed the standard set by the Pellet
Fuel Institute(PFI).
• Never use gasoline, gasoline-type lantern fuel,
kerosene, charcoal lighter fluid, or similar liquids to
start or ’freshen up’ a fire in this stove. Keep all such
liquids well away from the stove while it is in use.
•
A working smoke detector must be installed in the
same room as this product.
•
Install a smoke detector on each floor of your home;
incase of accidental fire from any cause it can provide
time for escape.
•
The smoke detector must be installed at least 15 feet
(4,57 M) from the appliance in order to prevent undue
triggering of the detector when reloading.
• Do not unplug the stove if you suspect a malfunction.
Turn the ON/OFF SWITCH to ”OFF’ and contact your
dealer.
•
Your stove requires periodic maintenance and
cleaning (see ”MAINTENANCE ”). Failure to maintain
your stove may lead to improper and/or unsafe
operation.
• Disconnect the power cord before performing any
maintenance! NOTE: Turning the ON/OFF Switch to
”OFF” does not disconnect all power to the electrical
components of the stove.
• Never try to repair or replace any part of the stove
unless instructions for doing so are given in this manual.
All other work should be done by a trained technician.
• Do not operate your stove with the viewing door
open. The auger will not feed pellets under these
circumstances and a safety concern may arise from
sparks or fumes entering the room.
•
Allow the stove to cool before performing any
maintenance or cleaning. Ashes must be disposed
in a metal container with a tight fitting lid. The closed
container of ashes should be placed on a non-
combustible surface or on the ground, well away from
all combustible materials, pending final disposal.
•
The exhaust system should be checked monthly
during the burning season for any build-up of soot or
creosote.
•
Do not touch the hot surfaces of the stove. Educate
all children on the dangers of a high-temperature
stove. Young children should be supervised when they
are in the same room as the stove.
•
The hopper and stove top will be hot during operation;
therefore, you should always use some type of hand
protection when refuelling your stove.
•
A power surge protector is required. This unit must be
plugged into a 110 - 120V, 60 Hz grounded electrical
outlet. Do not use an adapter plug or sever the
grounding plug. Do not route the electrical cord
underneath, in front of, or over the heater. Do not
route the cord in foot traffic areas or pinch the cord
under furniture.
• The heater will not operate during a power outage.
If a power outage does occur, check the heater for
smoke spillage and open a window if any smoke spills
into the room.
• The feed door must be closed and sealed during
operation.
•
Never block free airflow through the open vents of the
unit.
•
Keep foreign objects out of the hopper.
• The moving parts of this stove are propelled by high
torque electric motors. Keep all body parts away from
the auger while the stove is plugged into an electrical
outlet. These moving parts may begin to move at any
time while the stove is plugged in.
•
Do not place clothing or other flammable items on or
near this stove.
•
When installed in a mobile home, the stove must be
grounded directly to the steel chassis and bolted to
the floor. WARNING—THIS UNIT MUST NOT BE INSTALLED
IN THE BEDROOM (per HUD requirements). CAUTION—
The structural integrity of the mobile home floor, wall,
and ceiling/roof must be maintained.
• This appliance is not intended for commercial use.
•
CAUTION: Burning fuel creates carbon monoxide
and can be hazardous to your health if not properly
vented.
*This appliance is a freestanding heater. It is not intended to be attached to any type of ducting. It is not a furnace.
Safety Precautions
