
■
8
│
GB│IE
UAVS 450 A1
Clearing a material blockage
NOTE
►
In the event of a material jam, the appliance starts a short automatic
reverse run in order to release the material from the cutting blades so you
can remove it from the cutter opening
4
.
If this is not enough to remove the material being shredded, proceed as
described below.
♦
Press the
REV
button
r
(reverse) if the paper being shredded is jammed.
The appliance now goes into reverse and the material is ejected.
♦
Alternatively, press the
FWD
button
e
(forward) if the paper being shredded
is jammed. The appliance is now in forwards operation and the material that
is being shredded is pulled in again.
♦
Press the
AUTO
button
t
as soon as the jammed paper is cleared.
Turning the appliance off
NOTE
►
We recommend that you switch off the appliance and let it cool down for
about 10 minutes after 30 minutes of operation to prevent overheating.
♦
Press the
AUTO
button
t
to switch the appliance into standby mode. The
LED
t
goes out.
♦
Move the On/Off switch
3
on the rear of the appliance into position
O
to
switch the appliance off.
Overheating protection
This appliance is fitted with overheating protection. If the motor overheats due to
overloading, the appliance switches itself off automatically. The LED
t
lights
up continuously red until the motor has cooled down sufficiently.
If this occurs, do the following:
NOTE
►
The appliance is equipped with an active ventilation system
2
. Do not
switch off the appliance or disconnect it from the power supply while it is
still cooling.
♦
Allow the appliance to cool down for about 10 minutes.
After the motor has cooled down, the appliance is ready for operation again.
Содержание UAVS 450 A1
