UNITED OFFICE 320246 1901, Руководство по эксплуатации

Страница: 24 / 102

GB│IE
│ 21 ■ UAVK 180 A1
Shifting paper in the waste collector
The paper may fall unevenly into the waste collector and trigger the sensor
on the underside of the cutter attachment . This will cause the appliance to
stop, even though the waste collector is not full.
The power/bin full LED
-
flashes blue and beeps.
WARNING! – RISK OF INJURY!
► Pull the power plug out of the power socket to prevent unintended starting
of the appliance.
♦ Remove the cutter attachment from the waste collector using the
integrated carrying handles .
♦ Even out the paper.
♦ Place the cutter attachment onto the waste collector using the integrated
carrying handles so that the mains cable protrudes to the rear.
♦ Slide the AUTO/OFF/REV switch
!
to the AUTO position. The power/
bin full LED
-
continuously lights up blue. The appliance is now ready for
use.
Clearing a material blockage
In a paper jam, the paper is caught in the cutting blades.
During automatic feeding, the appliance will beep until the paper jam is cleared.
During manual feeding
.
, the overheat/overload LED
3
flashes red until the
paper jam has been cleared.
♦ Slide the
AUTO/OFF/REV
switch ! to the
REV
(reverse) position if the
material being shredded gets stuck. The appliance now goes into reverse
and the material is ejected.
The
power/bin full LED
-
lights up blue continuously.
♦ Pull the material being cut out of the appliance and then slide the AUTO/
OFF/REV switch
!
to AUTO .
The appliance is now ready for use.
Turning the appliance off
NOTE
► Regularly remove any residue left in the cutting blades with a suitable
object (e.g. brush or tweezers). Ensure that the appliance is unplugged
before doing this!
♦ Switch the appliance off by sliding the
AUTO/OFF/REV
switch ! to the
OFF position. The power/bin full LED
-
goes out.