PT630
Operation
Guide
Page
19
of
41
Send/No-send Leading Digit (SEND)
Send/No-send Check Digit (SEND)
Enable/disable Zero-Expansion (OFF)
EAN-13
Enable/disable decoding (ON)
Send/No-send Leading Digit (SEND)
Send/No-send Check Digit (SEND)
EAN-8
Enable/disable decoding (ON)
Send/No-send Check Digit (SEND)
EAN/UPC
ADD-ON
Disable/Optional/Required
(DISABLE)
Send/No-send Check Digit (SEND)
Code 128
Enable/disable decoding (ON)
EAN 128
Enable/disable decoding (ON)
Code 93
Enable/disable decoding (ON)
Code 32
Enable/disable decoding (ON)
User code 1 Enable/disable decoding (OFF)
User code 2 Enable/disable decoding (OFF)
3.2.3.2
ASCII Terminal Configuration
The
TERM
command enables the PT630 to run a built-in Terminal emulator. The PT630 will
operate as a dumb ASCII terminal when the user select this feature and disable the
FormCaching
menu.
When the TERM SETUP menu (shown below) appears on the PT630 LCD, proceed to set up the
portable terminal communication parameters. When finished go to the
User Mode
menu and press
2 (2.TERM) to make the PT630 operate as a dumb ASCII terminal.
Terminal ID
Each PT630 "Terminal" can be identified by an 8-character
string
Terminal ID
assigned by the user. Initially, the default
ID
is "PT630". Valid characters for assigning
Terminal ID
are alphanumeric characters ('A'-'Z', '0'-'9'). Hit [ENT] to
make the selection.
Online
Use the [ ] key to toggle between REMOTE and
LOCAL, then hit [ENT] to make the selection.
<<TERM SETUP>>
TERM ID.
PT630
<<TERM SETUP>>
ONLINE
REMOTE
1.DEV 2.TERM
3.MEM 4.FORM
5.PWR 6.PSWD
7.INI 8.DIAG
<TERM SETUP>
TERM I.D.
PT630
SUPERVISOR
MODE
PASSWORD:
<START MENU>
1.SUPERVISOR
2.WARM START
3.COLD START
