Unitary products group KBU060, Руководство по установке

Страница: 24 / 28

292427-BIM-A-0307
24 Unitary Products Group
ACCESSORIES
• ELECTRIC HEATER - Add 14-1/4” to unit height when used.
• SUPPLY AIR PLENUM - Add 27-1/2” to unit height when used.
• BASE - Add 20” to unit height when used.
FIGURE 17 - UNIT DIMENSIONS KBC090 & 120
1-23/32 KNOCKOUT
(Removed only when
Electric Heat Accessory
is used)
52-1/4
15-3/8
18-7/8
3-5/8
1
7/8" HOLE W/BUSHING
FOR CONTROL
WIRING
(Back Panel)
1-3/8" KNOCKOUT
FOR POWER WIRING (Back Panel)
Do not remove this knockout when
the unit is equipped with an Electric
Heat Accessory. Refer to detail of
the Heater Accessory for power
wiring access opening
4-1/4
5/8
16-1/8
25-7/8
15
AIR
OUT
BLOWER MOTOR
AND DRIVE
ACCESS PANEL
(This side only)
51-1/8
HOLE WITH GROM-
MET FOR
LIQUID LINE
HOLE WITH
GROMMET FOR
SUCTION LINE
4
2-5/8
1-3/8
1-3/4
1-1/8
25-1/8
2
7/8 O.D. DRAIN
CONN. (Must be
trapped)
48
2
1-5/8
23
AIR
IN
2-1/4
1
6-3/4
3-1/4
FILTER ACCESS PANEL
(When unit is installed in
a horizontal position,do
not block this area with
refrigerant piping)
8-3/8
TABLE 17: UNIT CLEARANCES KBC090 & 120
MINIMUM CLEARANCES 090-120
Side with RETURN AIR opening 24”
Side with SUPPLY AIR opening
1
24”
Side with PIPING CONNECTIONS
2
52”
Side opposite with PIPING CONNECTIONS 12”
Side with access for both POWER & CONTROL
WIRING
3,
-
Bottom
4
-
1.
Overall dimensions of the unit will vary if an electric
heater, a supply air plenum or a base is used.
2.
This dimension is required for removal of the coil. Only
26” is required for normal service.
3.
Although no clearance is required for service and oper-
ation, some clearance may be required for routing the
power and control wiring.
4.
Allow enough clearance to trap the condensate drain
line.
All dimensions are in inches. They
are subject to change without notice.
Certified dimensions will be provided
upon request.