Unitary products group EF-10, Инструкция по установке

Страница: 7 / 24

035-18550-001-A-0902
Unitary Products Group 7
rigging height above the top of the unit is less than 5
feet. See Figure 2.
BEFORE LIFTING A UNIT, MAKE SURE THAT ITS
WEIGHT IS DISTRIBUTED EQUALLY ON THE
STRAPS SO THAT IT WILL LIFT EVENLY.
Units may also be moved or lifted with a fork-lift. Slot-
ted openings in the base rails are provided for this pur-
pose.
LENGTH OF FORKS MUST BE A MINIMUM OF 54"
when lifting from either side.
Remove the nesting brackets from the four corners on
top of the unit. All screws that are removed to take
these brackets off must be replaced on the unit.
Do not use straps under the unit or through the
fork lift slots for lifting purposes. Sharp metal
edges can damage the straps and could result
in personal injury or equipment damage.
FIGURE 2 - TYPICAL RIGGING
Before lifting the unit, make sure that its
weight is distributed equally on the cables so
that it will lift evenly.
SPREADER
BAR
LIFTING
HOLES
FIGURE 3 - POINT LOADS
A
D
B
C
UNIT
4-POINT LOAD (lbs)
TOTAL A B C D
10 Ton 741 258 173 123 187